Flat Roofing

The roof had been poorly bridged to provide an intermediary room to access the garage which is detached from the building. The plastic glazing work done by previous builders had been running into the main roof, rather than onto the garage roof, which had caused many problems, including major le…

The existing torch on felt roof covering was removed, as it had been leaking severely under the felt flashings. 18mm OSB3 was installed over the joists to provide a flat surface to adhere the rubber too. 1.5mm EPDM rubber was glued to the timber roof deck. A black UPVC kerb trim was pinned arou…

The studio was decked with 18mm OSB3 timber sheet to provide a flat surface to adhere the 1.5mm EPDM rubber membrane. It was made to measure in one piece, and each of the roof openings carefully cut out, to ensure that no joints are in the rubber. The rubber was glued up the upstands of the sky…

The garage roof had a ply deck inside the parapet to provide a sound and flat support for the thicker 1.5mm EPDM rubber membrane to adhere to. This was made in 3 separate sections, with vulcanized joints, so that the membrane becomes chemically bonded, as if it were one piece. Two outlets were …